| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN KEY TO TURN OFF POWER TO MACHINE
|
| 3 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE.
|
| 4 |
|
PULL TO REMOVE THE HOSES. PLACE HOSES NEAR DRAIN AND REMOVE CAPS
|
| 6 |
|
REMOVE THE TANK BOLT ON RIGHT SIDE OF THE MACHINE.
| Ratchet-Socket metric 13mm |
|
|
| 7 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 8 |
|
REMOVE BRUSH GUIDE WHEEL WITH TWO 5MM ALLEN HEAD SCREWS
| Wrench-Allen metric 5.0mm |
|
|
| 9 |
|
REMOVE THE REMAINING ALLEN HEAD SCREWS AROUND THE BRUSH SHROUD
| Wrench-Allen metric 5.0mm |
|
|
| 10 |
|
LIFT UP TO REMOVE THE BRUSH SHROUD.
|
| 11 |
|
REMOVE THE MOTOR LEADS AT THE CONNECTION BLOCK TO THE LEFT OF THE MOTOR. USE A SMALL FLATHEAD SCREWDRIVER TO LOOSEN THE SET SCREWS.
| Screwdriver-flat tip |
|
|
| 12 |
|
PULL TO REMOVE THE SOLUTION LINES TO THE RIGHT OF THE MOTOR
|
| 13 |
|
UNDERNEATH THE DECK, LOCATE AND PULL TO REMOVE THE BRUSH DECK COTTER PIN
|
| 14 |
|
PULL BRUSH DECK OFF THE SHAFT TO REMOVE FROM MACHINE. TURN DECK UPSIDE DOWN AND PLACE ON WORK BENCH
|
| 16 |
|
PULL TO REMOVE THE SPRINGS FROM THE BOTTOM PLATE
|
| 17 |
|
USING SMALL FLATHEAD SCREWDRIVER, REMOVE SNAP RING AT THE HINGE FOR THE BOTTOM PLATE.
| Screwdriver-flat tip |
|
|
| 18 |
|
REMOVE THE SHAFT FROM THE BOTTOM PLATE HINGE AND LIFT OFF THE BOTTOM PLATE
|
| 19 |
|
REMOVE THE 5MM ALLEN HEADS AROUND THE BLACK PLASTIC BELT COVER
| Wrench-Allen metric 5.0mm |
|
|
| 20 |
|
LIFT OFF THE BLACK PLASTIC COVER TO EXPOSE THE BELT
|
| 21 |
|
WITH 10 MM SOCKET, LOOSEN AND REMOVE THE 3 MOTOR BOLTS FROM THE UNDERSIDE OF THE DECK.
| Ratchet-Deep socket metric 10mm |
|
|
| 22 |
|
REMOVE MOTOR, THEN REMOVE BELT.
|
| 23 |
|
lOOP NEW BELT OVER PULLEYS AND START THE MOTOR BOLTS, FINGER TIGHT. NEXT USE A LONG LEVER (SUCH AS A SCREWDRIVER) TO APPLY TENSION TO THE MOTOR MOUNTS BEFORE TOTALLY TIGHTENING DOWN THE 10MM BOLTS
| Ratchet-Deep socket metric 10mm |
|
| Screwdriver-flat tip |
|
|
| 24 |
|
REASSEMBLE DECK AND INSTALL BACK ON MACHINE.
|